The ordinary grab buckets used on construction sites always leak and shake materials during operation. This not only wastes materials but also easily damages the equipment. Our Mountain Cat industrial grab buckets were tested in the port of Zhejiang for half a year. Now, the efficiency of loading and unloading sand and stone materials has doubled, and the frequency of equipment maintenance has decreased by 60%. They are particularly convenient whether installed on a sliding loader or a telescopic boom forklift.
This grab has four real advantages:
- The alloy steel used for the teeth can withstand 8,000 hours of wear.
- The opening and closing are controlled by two oil cylinders, and there is no slipping when clamping wood or scrap iron.
- The quick-change interface can be directly matched with 90% of the Skid Steer Loaders on the market.
- The hydraulic cylinder is equipped with triple seals, and it won't be afraid of even the largest amount of dust.
Remember these points for daily maintenance:
① Clean the gravel in the tooth gap before the workday ends
② Check if there is any oil leakage in the oil cylinder every week
③ Apply grease to the pins once a month
④ Remember to spread out the grabber when it's not in use for a long time
Common questions asked by buyers:
Question: Can it be installed and used on the Mini Track Loader?
Answer: The complete conversion frame is fully equipped, and it can be adapted for all three models.
Question: What is the maximum weight it can handle?
Answer: The standard version can handle up to 1.2 tons, and the thickened version can reach up to 2.5 tons.
Question: Will the equipment get rusty during the rainy season?
Answer: It has been fully treated with galvanization, so it won't rust even when soaked in rainwater.
Question: How to replace when the tooth tip is worn out?
Answer: A single tooth plate can be replaced in just ten minutes. The accessories are all standard parts.
Question: What should we do if the hydraulic pipe bursts?
Answer: We have various types of rubber hoses in stock. They can be delivered domestically within 24 hours.
Q: How long is the warranty period?
A: The core components are covered for two years, and the handle parts are covered for one year.
When this grab was tested at the Qingdao Steel Factory, its efficiency in handling scrap steel was half that of the old equipment. All weld seams underwent flaw detection, and the pin shaft was made of the same alloy steel as that used in tanks. Please note that before installation, adjust the pressure valve first. If it is used with the Telescopic Handler, remember to slow down when turning. For bulk orders, a special toolbox will be sent, and technicians will be dispatched to teach the operation. Be careful not to use this grab to smash concrete blocks, as it is not a breaker.
